Mottled Blue Wool Coating
Mottled Blue Wool Coating
Mottled Blue Wool Coating
Mottled Blue Wool Coating
Mottled Blue Wool Coating
Mottled Blue Wool Coating

Mottled Blue
Wool Coating

 In stock
€44.25 /metre
Ordering cut fabric
Details Suitable patterns Alternatives

Description:

A high quality soft wool coating in midnight blue marl. This wool is beautifully bouncy and cosy and would be ideal for our Sanda coat or any other weighty winter coats.

  • 100% wool.
  • 150cm wide.
  • 13.3oz, 450gsm.
  • Country of orgin; Mexico.
  • Dry clean only.
  • As all computer monitors show colours differently, we recommend ordering a sample of the cloth to check it is the right colour and weight for your project. 
  • Thread match Gutermann Sew All 11.

Suitable Patterns

Show all suitable

Alternatives

Show all other alternatives

Resources

Sanda Jacket Hack for Thicker Woollens
Sanda Jacket Hack for Thicker Woollens

We chose to make a Sanda jacket in our luxurious thick alpaca in a slightly longer length. For this hack you will need to buy the Sanda pattern here.

Above, Sacha is wearing the Sanda in our Dusty Blush Alpaca Blend Wool.

This hack will require 30cms more self and lining fabric than required for the jacket version of the Sanda.

These are the changes we made to the pattern to make our sample:

We increased the overall length of the jacket, by adding 12cms to the FRONT(1) and BACK(2) pieces. Make sure you also add the same length to the FRONT AND BACK YOKE FACING(4) and FRONT AND BACK YOKE LINING(10) pieces.

We added 1.5cm around the whole PATCH POCKET(8) to make it a little bigger. We did the same with the PATCH POCKET LINING(12) but didn’t add anything to the top edge of this piece.

We lowered the position of the patch pockets so they sit 5cm up from hemline.

Due to the thickness of the cloth we altered the sleeve pattern at the cuff to make the turn up a little more substantial. This is how we did it:

STEP 1: Cut through the FOLDLINE near the bottom of the sleeve as shown by the thicker line below:

STEP 2: Place some paper behind the pieces and add in 2cm total, stick down ensuring the lines remain parallel.

Redraw the FOLDLINE in – in the midpoint between the two pieces so you have 1cm above and below the new FOLDLINE.

Also draw in a new HEMLINE – 5cms below the new FOLDLINE.

 

STEP 3: Measure outwards either side of the new FOLDLINE by 1cm – see image below.

Join this point back in to the two marked HEMLINES. This will stop the cuff from hugging the sleeve hem too tightly and allow it to sit nicely when turned up.

Below are some suggestions of wools that would be perfect for this Sanda hack. 
From left to right: Seaglass Wool Coating, Mojito Wool Coating, Towner Navy Wool Coating, Emerald Alpaca Blend Wool, Dusty Blush Alpaca Blend Wool, Yogi Alpaca Blend Wool, Fall Trail Wool Coating, Mottled Blue Wool Coating, Vermont Wool Coating.
Read More
Show all other resources